Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 650)

show vrf output descriptions (Continued) TABLE 135
This field Displays
IP Router-Id The 32-bit number that uniquely identifies the router.
Number of Unicast Routes The number of Unicast routes configured on this VRF.
The show who command displays information about the management VRF from which the Telnet and
SSH connection has been established.
device(config)# show who
Console connections:
established, monitor enabled, privilege super-user, in config mode
1 minutes 47 seconds in idle
Telnet server status: Enabled
Telnet connections (inbound):
1 established, client ip address 10.53.1.181, user is lab, privilege super-user
using vrf default-vrf.
2 minutes 46 seconds in idle
2 established, client ip address 10.20.20.2, user is lab, privilege super-user
using vrf mvrf.
16 seconds in idle
3 closed
4 closed
5 closed
Telnet connections (outbound):
6 established, server ip address 10.20.20.2, from Telnet session 2, ,
privilege super-user
using vrf mvrf.
12 seconds in idle
7 closed
8 closed
9 closed
10 closed
SSH server status: Enabled
SSH connections:
1 established, client ip address 10.53.1.181, privilege super-user
using vrf default-vrf.
you are connecting to this session
3 seconds in idle
2 established, client ip address 10.20.20.2, privilege super-user
using vrf mvrf.
48 seconds in idle
3 closed
4 closed
5 closed
6 closed
7 closed
8 closed
9 closed
10 closed
11 closed
12 closed
13 closed
14 closed
15 closed
16 closed
Syntax: show who
To display the packets and sessions rejection statistics due to failure in management VRF validation,
enter the following command.
device(config)# show management-vrf
Management VRF name : sflow
Management Application Rx Drop Pkts Tx Drop Pkts
SNMP Engine 0 11
RADIUS Client 0 0
TFTP Client 0 0
Configuring Multi-VRF
650 FastIron Ethernet Switch Layer 3 Routing Configuration Guide
53-1003087-04