Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 497)

Displaying information for a specific route
To display BGP4 network information by specifying an IP address within the network, enter a command
such as the following at any level of the CLI.
device# show ip bgp 10.3.4.0
Number of BGP Routes matching display condition : 1
Status codes: s suppressed, d damped, h history, * valid, > best, i internal
Origin codes: i - IGP, e - EGP, ? - incomplete
Network Next Hop Metric LocPrf Weight Path
*> 10.3.4.0/24 192.168.4.106 100 0 65001 4355 1 1221 ?
Last update to IP routing table: 0h11m38s, 1 path(s) installed:
Gateway Port
192.168.2.1 2/1
Route is advertised to 1 peers:
10.20.20.2(65300)
Syntax: show ip bgp [ route ] ip-addr/prefix [ longer-prefixes ] | ip-addr
If you use the route option, the display for the information is different, as shown in the following
example.
device# show ip bgp route 10.3.4.0
Number of BGP Routes matching display condition : 1
Status A:AGGREGATE B:BEST b:NOT-INSTALLED-BEST C:CONFED_EBGP D:DAMPED
E:EBGP H:HISTORY I:IBGP L:LOCAL M:MULTIPATH m:NOT-INSTALLED-MULTIPATH
S:SUPPRESSED F:FILTERED s:STALE
Prefix Next Hop MED LocPrf Weight Status
1 10.3.4.0/24 192.168.4.106 100 0 BE
AS_PATH: 65001 4355 1 1221
Last update to IP routing table: 0h12m1s, 1 path(s) installed:
Gateway Port
192.168.2.1 2/1
Route is advertised to 1 peers:
10.20.20.2(65300)
show ip bgp route output descriptions TABLE 99
This field Displays
Number of
BGP4 Routes
matching
display
condition The number of routes that matched the display parameters you entered. This is the number of
routes displayed by the command.
Status codes A list of the characters the display uses to indicate the route’s status. The status code appears in
the left column of the display, to the left of each route. The status codes are described in the
command’s output.
NOTE
This field appears only if you do not enter the route option.
Prefix The network address and prefix.
Next Hop The next-hop device for reaching the network.
Metric The value of the route’s MED attribute. If the route does not have a metric, this field is blank.
Displaying information for a specific route
FastIron Ethernet Switch Layer 3 Routing Configuration Guide 497
53-1003087-04