Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 550)

NOTE
Portions of this display are truncated for brevity. The purpose of this display is to show all possible
fields that might display rather than to show complete output.
Syntax: show ipv6 bgp attribute-entries
show ipv6 bgp attribute-entries output descriptions TABLE 107
This field... Displays...
Total number of BGP
Attribute Entries The number of entries contained in the device’s BGP4+ route-attribute entries table.
Next Hop The IPv6 address of the next hop router for routes that have this set of attributes.
MED The cost of the routes that have this set of attributes.
Origin The source of the route information. The origin can be one of the following:
• EGP - The routes with this set of attributes came to BGP4+ through EGP.
• IGP - The routes with this set of attributes came to BGP4+ through IGP.
• INCOMPLETE - The routes came from an origin other than one of the above. For
example, they may have been redistributed from OSPFv3 or RIPng.
When BGP4+ compares multiple routes to a destination to select the best route, IGP is
preferred over EGP, and both are preferred over INCOMPLETE.
Originator The originator of the route in a route-reflector environment.
Cluster List The route-reflector clusters through which this set of attributes has passed.
Aggregator Aggregator information:
• AS Number shows the AS in which the network information in the attribute set was
aggregated. This value applies only to aggregated routes and is otherwise 0.
• Router-ID shows the router that originated this aggregator.
Atomic Whether the network information in this set of attributes has been aggregated and this
aggregation has resulted in information loss:
• TRUE - Indicates information loss has occurred
• FALSE - Indicates no information loss has occurred
• None - Indicates this attribute is not present.
NOTE
Information loss under these circumstances is a normal part of BGP4+ and does not
indicate an error.
Local Pref The degree of preference for routes that use this set of attributes relative to other routes
in the local AS.
Communities The communities that routes with this set of attributes are in.
Configuring BGP4+
550 FastIron Ethernet Switch Layer 3 Routing Configuration Guide
53-1003087-04