Displaying global ip configuration information – Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide User Manual
Page 133
Displaying global IP configuration information
To display IP configuration information, enter the following command at any CLI level.
device# show ip
Global Settings
ttl: 64, arp-age: 10, bootp-relay-max-hops: 4
router-id : 10.95.11.128
enabled : UDP-Broadcast-Forwarding Source-Route Load-Sharing RARP OSPF VRRP-
Extended VSRP
disabled: Route-Only Directed-Broadcast-Forwarding BGP4 IRDP Proxy-ARP RIP
VRRP ICMP-Redirect
Static Routes
Index IP Address Subnet Mask Next Hop Router Metric Distance
1 0.0.0.0
0.0.0.0 10.157.23.2 1 1
Policies
Index Action Source Destination Protocol Port Operator
1 deny 10.157.22.34 10.157.22.26
tcp http =
64 permit any any
Syntax: show ip
NOTE
This command has additional options, which are explained in other sections in this guide, including the
sections following this one.
This display shows the following information.
CLI display of global IP configuration information - Layer 3 switch
TABLE 20
Field
Description
Global settings
ttl
The Time-To-Live (TTL) for IP packets. The TTL specifies the maximum number of router
hops a packet can travel before reaching the Brocade router. If the packet TTL value is
higher than the value specified in this field, the Brocade router drops the packet.
arp-age
The ARP aging period. This parameter specifies how many minutes an inactive ARP entry
remains in the ARP cache before the router ages out the entry.
bootp-relay-max-hops The maximum number of hops away a BootP server can be located from the Brocade
router and still be used by the router clients for network booting.
router-id
The 32-bit number that uniquely identifies the Brocade router.
By default, the router ID is the numerically lowest IP interface configured on the router.
enabled
The IP-related protocols that are enabled on the router.
disabled
The IP-related protocols that are disabled on the router.
Static routes
Index
The row number of this entry in the IP route table.
IP Address
The IP address of the route destination.
Displaying global IP configuration information
FastIron Ethernet Switch Layer 3 Routing Configuration Guide
133
53-1003087-04