FUJITSU SPARC ENTERPRISE M8000 - Manual (Page 82)

2-44 SPARC Enterprise M8000/M9000 Servers Service Manual • August 2009
2.9.3 prtconf Command
Similar to the show-devs command run at the ok prompt, the prtconf command
displays the devices that are configured.
The prtconf command identifies hardware that is recognized by the Solaris OS. If
hardware is not suspected of being bad yet software applications are having trouble
with the hardware, the prtconf command can indicate if the Solaris OS software
recognizes the hardware, and if a driver for the hardware is loaded.
==================== Hardware Revisions ====================
System PROM revisions:
----------------------
OBP 4.24.4 2007/11/05 10:27
=================== Environmental Status ===================
Mode switch is in UNLOCK mode
=================== System Processor Mode ===================
SPARC64-VII mode
bash-3.2#