FUJITSU SPARC ENTERPRISE M8000 - Manual (Page 350)

19-4 SPARC Enterprise M8000/M9000 Servers Service Manual • August 2009
c. From here, perform operations according to the guidance displayed in the
maintenance menu.
Check the states of LEDs (POWER LED: off; CHECK LED: blinking) on the
DDC to be replaced, and begin the actual replacement work when a message
instructing the user to replace the target DDC is displayed. Leave the
maintenance menu as is until
Step 6 .
3. Connect the wrist strap clip to a cabinet grounding port, and attach the band of
the wrist strap to one of your wrists.
4. Remove the DDC to be replaced.
a. Using a Phillips screwdriver, turn the knob screw securing the bottom
eject/lock lever 90 to 180 degrees to unlock the lever. (Turn the knob screw
while lightly pulling the lever with one hand.)
b. Unlock the eject/lock levers to pull the DDC off the backplane.
c. While grasping the eject/lock levers, pull out the DDC slowly from the slot.