FUJITSU SPARC ENTERPRISE M8000 - Manual (Page 287)

Chapter 13 PCI Slot Device Replacement 13-13
e. Using a Phillips screwdriver, tighten the green screw.
Be sure to stop tightening the screw when the bottom of the screw head is flush
with the projecting part of the handle. Otherwise, over tightening the screw
may cause the projecting part of the handle to break. (See
FIGURE 13-10 .)
FIGURE 13-10 Tightening the Screw
Caution – Align the PCI card with the slot guides, insert it carefully, and secure it
firmly.
Caution – Do not forcibly push the PCI card when inserting it, even if it is not
moving smoothly. If the PCI card is forcibly inserted despite the presence of any
obstruction in the slot or any problem with a connector pin, serious damage may
result.
Screw head Projecting part of the handle