FUJITSU SPARC ENTERPRISE M8000 - Manual (Page 309)

15-1
C H A P T E R
15
Tape Drive Unit Replacement
This chapter explains the replacement procedure for the tape drive unit (TAPEU). It
covers the following:
■ Section 15.1, “Overview of the Tape Drive Unit” on page 15-1
■ Section 15.2, “Active Replacement” on page 15-5
■ Section 15.3, “Hot Replacement” on page 15-9
■ Section 15.4, “Cold Replacement” on page 15-10
There are three methods for replacing a tape drive unit: active replacement, hot
replacement, and cold replacement. For the definition of each type of method, see
Section 4.1, “Types of Replacement Procedures” on page 4-2 .
Note – Contact your sales representative for tape drive unit options on SPARC
Enterprise M8000/M9000 servers.
15.1 Overview of the Tape Drive Unit
This section provides an overview of tape drive unit s and describes their mounting
locations. Since the tape was originally called a digital audio tape, it is sometimes
referred to as a DAT.
One tape drive unit can be mounted in each cabinet. Active replacement and hot
replacement can be performed on a tape drive unit.
FIGURE 15-1 , FIGURE 15-2 , and FIGURE 15-3 show the mounting locations of tape drive
unit.