FUJITSU SPARC ENTERPRISE M8000 User Manual
Page 269
Chapter 12
Hard Disk Drive (HDD) Replacement
12-3
1. Unlock and open a door of the server.
For details, see
.
2. Prepare for the replacement of the target HDD.
From the OS, execute the cfgadm -a command to verify Ap_Id.
Stop the use of HDD by the application and disconnect the HDD from the OS.
The procedure of disconnecting the HDD from the OS varies depending on
whether or not using the disk mirroring software or other supporting software.
When you are not using such kind of software, you can use the cfgadm
command to disconnect the target from the OS. When you are using the above
software, see the manual of that software for how to disconnect the disk.
The READY LED (green) of the HDD is turned off.
3. Blink the CHECK LED of the HDD to be replaced.
From the OS, execute the cfgadm -x led=fault,mode=blink
4. Connect the wrist strap clip to a cabinet grounding port, and attach the band of
the wrist strap to one of your wrists.
5. Remove the HDD unit to be replaced.
a. Press the square push button on the HDD unit to be replaced.
The eject/lock lever protrudes at an angle of about 45 degrees.
b. Pull the eject/lock lever to an angle of about 90 degrees to release the lock.
c. While grasping the eject/lock lever, pull out the HDD unit slowly from the
slot.