FUJITSU SPARC ENTERPRISE M8000 - Manual (Page 107)

Chapter 4 FRU Removal Preparation 4-13
The command is menu-driven. The example continues using a FAN unit.
The replacefru command will automatically test the status of the component after
the disconnecting off and replace has finished.
Select [1,2|c:cancel] :1
---------------------------------------------------
Maintenance/Replacement Menu
Please select a FAN to be replaced.
No. FRU Status
--- --------------- ------------------
1. FAN_A#0 Normal
2. FAN_A#1 Normal
3. FAN_A#2 Normal
4. FAN_A#3 Normal
---------------------------------------------------
Select [1-4|b:back] :1
You are about to replace FAN_A#0.
Do you want to continue?[r:replace|c:cancel] :r
Please confirm the Check LED is blinking.
If this is the case, please replace FAN_A#0.
After replacement has been completed, please select[f:finish] :f