FUJITSU SPARC ENTERPRISE M8000 User Manual

Page 385

Chapter 20

Backplane Replacement

20-29

FIGURE 20-18

Removing the FANBP (Rear of M9000)

9. Place the removed BP on an antistatic conductive mat.

10. Mount the replacement BP by following the removal instructions in

and

Step 8

in reverse order.

Note –

To mount a FAN BP on a fan shelf that has a guide pin, align the FAN BP

with the guide pin during mounting.

Caution –

Be sure not to hit connector parts of the BP against anything. Otherwise,

the connection pins may be seriously damaged.

11. Switch on all main line switches for the AC section (ACS) in the power supply

system.

12. Confirm that the XSCF STANDBY LED (green) on the operator panel remains

lit. If it is blinking, wait until it remains lit.