FUJITSU SPARC ENTERPRISE M8000 - Manual (Page 279)

Chapter 13 PCI Slot Device Replacement 13-5
Caution – When removing cables such as LAN cable, if your finger can't reach the
latch lock of the connector, press the latch with a flathead screwdriver to remove the
cable. Forcing your finger into the clearance can cause damage to the PCI card.
a. Using a Phillips screwdriver, loosen the green screw securing the lever.
b. While grasping the upper part of the PCI cassette, pull the lever until it is
stopped, and continue pulling it to pull out the PCI cassette.
c. Place the removed PCI cassette on an antistatic conductive mat.
FIGURE 13-2 Removing the PCI Cassette
9. Remove the PCI card from the PCI cassette. (Perform this work on the
conductive mat.)
1
2