FUJITSU SPARC ENTERPRISE M8000 - Manual (Page 136)

4-42 SPARC Enterprise M8000/M9000 Servers Service Manual • August 2009
4.7.1.3 For Server Using Three-phase Power Feed
Note – The server using three-phase power feed does not have any cable holder. In
this case, fasten the cables by running the hook-and-loop fastener through the slit
between the bracket at the cable holder mounting location and a column in the
cabinet. (
FIGURE 4-13 shows the fastening location on the left route.)
FIGURE 4-13 Cable Routing of the Server Using Three-Phase Power Feed
6. Fasten the cables running along the left route to the cable holder with a long
hook-and-loop fastener. (See (4) in FIGURE 4-14 .)
7. Allow 12 cables of all the cables running along the right route to hang along
the right frame. (See (5) in FIGURE 4-14 .)
8. Run the remaining cables from the right side to the left side while taking care
to prevent the cables from blocking the ventilation slits. (See (6) in FIGURE 4-14 .)
Note – Fujitsu recommends running the cables above the handle of the FAN unit.
9. Fasten 24 cables with a short hook-and-loop fastener to the handle of the fan
shelf. (See (7) in FIGURE 4-14 .)
Location for Attaching a Hook-and-loop Fastener Attached Hook-and-loop Fastener
Column of cabinet Cable holder
mounting bracket
Hook-and-loop fastener