FUJITSU SPARC ENTERPRISE M8000 - Manual (Page 179)

Chapter 6 Replacement of CPU/Memory Board Unit (CMU), CPU, and DIMM 6-27
6.5.1 Replacing a CPU Module
To replace the CPU module, use the CPU Module insertion/extraction tool. Side A is
for insertion, and side B is for extraction. The CPU Module insertion/expansion tool
is stored inside the server. In the SPARC Enterprise M8000 server, the tool can be
found on the left-side wall when the front door of the server is open. In the SPARC
Enterprise M9000 server base cabinet, the tool can be found on the upper part of the
unit when the rear door is open.
In the SPARC Enterprise M9000 server expansion cabinet, there is no
insertion/extraction tool.
FIGURE 6-9 CPU Module Insertion/Extraction Tool
A
B