Grass Valley LVS 100 v.3.15 - Manual (Page 46)

Installation
1-14
Profile LVS Event Management System Instruction Manual
Initial Power On
Refer to the Profile Installation Manual for initial power on.
NOTE. To prevent error conditions, make sure that at least the keyboard, mouse,
and monitor are connected before applying power to the Profile.
1. Turn on the power of the Live Controller (see Figure 1–8), the monitor, and
the related equipment connected to the Profile.
2. Make sure you first turn the Profile rear–panel Power switch to ON, then
turn the front–panel Standby/Power On switch to ON.
When power is applied, the Profile system will begin its start up routine.
When system logon is complete and the Windows NT appears, proceed to the
Software Installation instructions.