Grass Valley LVS 100 v.3.15 User Manual
Page 116
System Configuration and Startup
3-26
Profile LVS Event Management System Instruction Manual
When previous scenes and highlights are deleted:
No restrictions apply.
When previous scenes and highlights are not deleted:
Scenes and highlights recorded by the LVS are managed solely by timecode. The
LVS application will not allow duplication of timecode. Therefore, LVS will not
allow you to operate the system continuously for more than 24 hours, even if
recording is paused during that span of time. When 24 hours have passed since
the time recording began, the system stops recording, regardless of the remaining
disk capacity.
To alleviate this condition, you should preset the timecode to a time immediately
after the end of the previous recording. This will maximize recording time.
The following times are displayed for your convenience.
H Record Start Timecode
H Record End Timecode
H Record Capacity
When Timecode Preset setup is completed, click OK. This will open the various
LVS windows, as described in the next section.