Grass Valley LVS 100 v.3.15 - Manual (Page 295)

Profile LVS Event Management System Instruction Manual
9-5
Removal and Installation Procedures
This subsection contains procedures for removing and installing mechanical and
electrical modules in the Live Controller.
Preparation
This subsection contains the following information:
H Preparatory information needed to properly do the procedures that follow
H A list of equipment required when removing modules
H Procedures for removing and installing electrical and mechanical modules
WARNING. To avoid possible personal injury or damage to Live Controller
components, read Preparation for Use on page 7–1. Before doing this or any
other procedure in this manual, read the General Safety Summary on page xv
and the Service Safety Summary on page s-i.
To avoid possible personal injury or death, disconnect the power cord from the
line voltage source before doing any procedures in this subsection.
NOTE. Read these general instructions before removing a module.
First read the Summary of Procedures that follows to understand how the
procedures are organized. Then read Equipment Required to find out the tools
needed to remove and install modules.
General Instructions