Grass Valley LVS 100 v.3.15 - Manual (Page 179)

Timeline Window
Profile LVS Event Management System Instruction Manual
4-61
Figure 4-35: Target Time Set Dialog Box
Adding or Inserting Scenes
There are two modes, Normal and Insert, to place scenes onto the timeline.
In Normal mode, adding scenes to the timeline affects the position of the other
events in the timeline, or it changes the duration of the material in the timeline.
In Insert mode, the positions of the other events are not affected, and the total
duration of the material in the timeline is unchanged, except if you add events to
the end of the timeline.
For example, when you insert a scene C between events A and B in Normal
mode, event B will be pushed to the right, and scene C is just placed between
scenes A and B. The duration of the timeline increases by the duration of
scene C. This is sometimes called building-block mode.
Performing the same operation in insert mode, however, will result in scene C
replacing material from scene B. The total timeline duration remains unchanged.