Grass Valley LVS 100 v.3.15 - Manual (Page 138)

LVS Controller Window (Record Controller)
4-20
Profile LVS Event Management System Instruction Manual
Acceleration and Deceleration Buttons 
Click and hold the +
D (Accelerate)
button or –
D (Decelerate) buttons, to adjust the Profile playback speed. The
acceleration and deceleration rates are set with the slide bar.
The range of the –
D button is from 0.00 to 1.00, and the +D button from 1.00
to 2.00. When the mouse button is released, original playback speed will be
restored (1.0).
Through careful use of these controls, you can manually synchronize a Profile
output to an external signal.
ACG.. Early versions of the Live Controller may not allow you to successfully
synchronize signals. This is because the Live Controller sends a STOP signal to
the Profile system during the synchronization operations. If you have an early
Live Controller, you can: replace the Live Controller firmware with version 1.20
or higher, turn off the power to the Live Controller, or disconnect the Live
Controller from the Profile system.
Table 4-2: Keyboard Keys for Manual Synchronization
Keys Descriptions
Right Arrow ( ← ) Same as the +D (Acceleration) button
Left Arrow ( → ) Same as the -D (Deceleration) button
Up Arrow ( ↑ ) Same as the right arrow button in the Slide Bar
Down Arrow ( ↓ ) Same as the left arrow button in the Slide Bar
Page Up Moves the Slide Bar to the right by +0.1
Page Down Moves the Slide Bar to the left by -0.1
Home Moves the Slide Bar to the far left edge
End Moves the Slide Bar to the far right edge