Grass Valley LVS 100 v.3.15 - Manual (Page 134)

LVS Controller Window (Record Controller)
4-16
Profile LVS Event Management System Instruction Manual
Creating Scenes
1. Select a Record Resource from A to D by clicking the corresponding button.
These letters correspond to the resource groups assigned in the Resource
Setup tab of the Configuration window.
2. Start recording by clicking on the REC button.
3. To create a scene:
a. Click the MARK button to set the IN point of a scene.
b. Click the ENTER or ENT/CUE button to set the OUT point of the
scene.
Repeat steps a and step b as necessary. Each scene will be created in the
Scene window.
4. Stop recording by clicking on the STOP button.
Playing Scenes
1. Select a Playback Resource from A to B by clicking the corresponding
button. These letters correspond to the resource groups assigned in the
Resource Setup tab of the Configuration window.
2. Select an output mode by clicking either the EE button or the PB button.
3. Select a mode by clicking either the CONT button or the STEP button.
4. Select a scene in the Scene window by clicking its icon.
5. Start playing by clicking the PLAY button.
6. Stop playing by clicking the STOP button.
Synchronization
The Profile output signal can be manually synchronized to an external signal by
using following procedure.
1. Prepare two picture monitors to compare the video output from the Profile
system and the video of the external signal.
2. Click the Sync button to open the Manual Synchronization panel. See
Figure 4–12.