Grass Valley LVS 100 v.3.15 - Manual (Page 255)

Live Controller
Profile LVS Event Management System Instruction Manual
6-11
SEARCH 
To search to a specific location (absolute scene number or time
code), enter a numeric value and then press this button.
The system will pause at the In point of the video searched for. (In scene,
highlight and event search mode, the search is to the corresponding In point
minus Preroll time.) For example: to search for scene 14, press SCENE, 1, 4,
SEARCH; to search for a specific time code location, press TIME,
2–0–1–1–4–0–0, SEARCH.
AĂ" 
Relative search is executed by entering a numeric value and then
pressing one of these button. For example: to search ahead three scenes, press
SCENE, 3,
"; to search back 2.5 minutes, press TIME, 2–3–0–0–0, A.
If you press
A or " without entering a numeric value, it is assumed that the
value of 1 was entered. When you press this button the system pauses at the start
point of the video searched for. (In scene, highlight and event search mode, the
search is to the corresponding in point minus preroll time.)
TOP 
The system cues to the start point (In point minus any set Preroll) of the
current scene, highlight, or event depending on which is selected.
Scene
IN OUT
Pre-Roll time Post-Roll time
CUE UP by SEARCH, A, " or TOP button
Figure 6-9: CUE UP Point
ACG.. If you need to cue to the In point, set 0 as one of the three preset Preroll
parameters in the Configuration Window.