Grass Valley LVS 100 v.3.15 - Manual (Page 298)

Removal and Installation Procedures
9-8
Profile LVS Event Management System Instruction Manual
Opening the Operation Panel
How to remove the lever and open the operation panel are included in this
procedure.
The procedure to remove the lever and open the operation panel varies
depending on your instrument’s serial number. If your Live Controller’s serial
number is J310130 or higher, proceed with steps 1 – 6 below (see Figure 9–1):
1. Move the lever forward until it stops.
2. Insert the 5 mm (long shank) Phillips screwdriver into the slit of the
escutcheon, as shown in Figure 9–1.
3. While pulling the lever upward, slowly turn the screwdriver counterclock-
wise until the lever is free.
4. Use the 2.5 mm hex wrench to remove the two screw on the front of the
instrument.
5. Open the cover by lifting up the front edge of the operation panel until it
stops.
6. With your finger, push the hinged support bracket to lock the operation panel
open. See Figure 9–3.
Lever
Operation Panel
(Top Cover)
To remove the lever, loosen
the screwin the escutcheon.
Escutcheon
Screws M3 5MM, SCH
Figure 9-1: Operation Panel Removal (Serial NO. J310130 or higher)