Grass Valley LVS 100 v.3.15 - Manual (Page 271)

Profile LVS Event Management System Instruction Manual
7-1
Preparation for Use
This section describes how to prepare the Live Controller for use. The informa-
tion describes these items:
H Proper operating environment.
H Checking power cord and line voltage configurations.
H Checking the fuse.
H Power-on and power-off cycles.
Supplying Power
Before installing the Live Controller, note these precautions:
WARNING. To avoid equipment failure, potential fire, or personal shock hazards,
do not exceed the maximum rated operating voltage of 250 V between the
voltage-to-ground (earth). The Live Controller operates on single-phase power.
It has a three-wire power cord with two-pole, three-terminal grounding plugs.
Before attempting to connect the Live Controller, make sure source power has a
suitable two-pole, three-terminal grounding-type plug.
To avoid personal shock hazard, do not contact conductive parts. All accessible
conductive parts are directly connected through the grounding conductor of the
power cord to the grounded contact of the power plug.
To avoid personal shock hazard, insert the power plug only in a mating
receptacle with a grounding contact where earth ground has been verified by a
qualified service person. Also, for electrical shock protection, make the
grounding connection before making connection to the Live Controller.
Power Cord Information
Refer to Appendix B Live Controller Option and Accessories for power cord
information.