Grass Valley LVS 100 v.3.15 - Manual (Page 104)

System Configuration and Startup
3-14
Profile LVS Event Management System Instruction Manual
Scene
IN OUT
Pre-Roll time Post-Roll time
Post-Roll 
Post–Roll can be set between 00:00 and 59:29 (seconds, frames).
The default value is 05:00.
Auto In Point 
In the 2–Channel mode, a scene can be generated by simply
pressing the ENTER/CUE UP button, without pressing the MARK button. The
point when the ENTER/CUE UP button is pressed becomes the OUT point, and
the IN point is set to the OUT point minus this parameter (back timed).
The effective range is between 00:05:00 and 59:59:29. The default value is
05:00.
ENTER/CUE UP
Scene
IN OUT
Auto In Point
ACG.. Do not set this parameter to any value shorter than five seconds. Playing
or cueing up to something in less than five seconds after it has been recorded
may cause the system to play or cue to black.
Save Before In / Save After Out 
During disk cleanup, marked scenes and
highlights as well as library material are protected. This setting determines how
much pad on each side of a scene’s and/or highlight’s IN and OUT is saved.
The effective range for both parameters is between 00:00:00 and 59:59:29
(minutes, seconds, frames). The default value is 01:00:00 for both parameters.
Scene
IN OUT
Save before In Save after Out