Grass Valley LVS 100 v.3.15 - Manual (Page 248)

Live Controller
6-4
Profile LVS Event Management System Instruction Manual
Functions
The start and stop of recording, and creation of scenes are controlled by the
buttons in REC area.
Figure 6-4: Buttons in the REC Area
MARK 
Specifies the start of a scene. The time at which the MARK button is
pressed becomes the IN point of the scene. If the MARK button is pressed more
than one time before pressing the ENTER/CUE UP button, the time when the
MARK button is pressed last will be the IN point.
MARK ENTER/CUEĂUP
Scene
IN OUT
If you press the MARK button while holding down the SHIFT button, a scene
is created. The IN point is set at a time five seconds before the time when the
button is pressed, and the time the button is pressed will be the OUT point. The
system cues up at the IN point and the OUT button in the EDIT area (see page
3–58) flashes. This creates a scene with a temporary Out point and puts the Live
Controller into a mode that allows the operator to manually adjust the picture to
the desired Out point and entering that by pressing the OUT button.
SHIFT + MARK
Scene
IN OUT
5 seconds
ENTER/CUE UP 
Specifies the Out point, or end of a scene. The system cues to
the IN point and the scene can be played immediately.
REC Area