beautypg.com

Applying power to your drive, Recording your drive and motor information – Rockwell Automation 1336E IMPACT Adjustable Frequency AC Drive User Manual V 1-4.XX User Manual

Page 101

background image

Starting Up Your System

6-3

Applying Power to Your Drive

When the pre-power checks are completed, apply incoming power.
System design determines how you apply power. Make sure that you
know the safety controls associated with your system before applying
power. Only apply power if you thoroughly understand the 1336
IMPACT drive and the associated system design.

Measure the incoming line voltage between L1 & L2, L2 & L3, and
L1 & L3. Use a Digital Multimeter (DMM) on AC volts, highest
range (1000V AC). The input voltage should equal the drive rated
input voltage present on the drive’s nameplate within

±10%. If the

voltage is out of tolerance, verify that the drive rating is correct for the
application. If it is correct, adjust the incoming line voltage to within
±10%. Refer to Appendix D, Derating Guidelines, for the drive
current derating requirements for voltages above nominal to +10%.

Recording Your Drive and
Motor Information

Record the following information. You will need this information for
the start up routine and for any future servicing, if needed.

Table 6.A
Drive and Motor Information

Drive Nameplate Data

Catalog Number: ___________________________________________

Serial Number: _____________________________________________

Series: ___________________________________________________

AC Input:____________ Volts: _______________Amps:____________

AC Output: __________ Volts: _______________Amps:____________

Horsepower Rating: _________________ kW:____________________

Motor Nameplate Data

Catalog Number: ___________________________________________

Serial Number: _____________________________________________

Series: ___________________________________________________

AC Input:____________ Volts: _______________Amps:____________

Horsepower Rating: _________________ kW:____________________

Poles: ________________________ (May be located on the nameplate.)

RPM: ________________________

Hz: __________________________

Encoder Nameplate Data

Optional

Catalog Number: ___________________________________________

Serial Number: _____________________________________________

Series: ___________________________________________________

Input Power Supply: _____________________________________ Volts

Input Signal Level: ______________________________________ Volts

Output Signal Level: _____________________________________ Volts

Output Type: _______________________________________________

Pulse Per Revolution: _____________________________________PPR

Maximum Speed: ___________________________________________

Maximum Frequency: ________________________________________

Revision Levels

Main Control Board: _________________________________________

Gate Driver Board: __________________________________________

Jumper Settings

(Board Dependent)

____________________________

___________________________

____________________________

___________________________