Lenze ETC Motion Control - Manual (Page 55)

Getting started
ETC PLC programming with CoDeSys
Configuring the control system in the ETC−CoDeSys
2
2.11
2.11.2
l
55 EDSTCXN EN 2.0
)
Note!
New modules are added at the end of the list. To insert a new
module before an existing one, select the existing module and
add it via the right mouse button with Element einfügen (Insert
Element).
A module can be removed from the list via the right mouse
button and Delete.
Each module that is configured in the control system requires an EDS file. The
EDS file belonging to the module must be located in the target directory of
the selected control system (in this case Lenze).
An EDS file contains entries of keywords that describe the property of the
module with the respective values.
In the case of modules from third−party manufacturers, the corresponding
EDS files must be copied into the target directory of the control system.
Description of the module in
the EDS file