Lenze ETC Motion Control - Manual (Page 332)

ETC−MMI
Appendix
Configuration file (DELPHMMI.INI)
7
7.8
7.8.3
l
332 EDSTCXN EN 2.0
Description Term Section
[WerkzeugVerwaltung] Determination of the internal tool
management (see documentation on the
standard HMI).
Wsk=default.wsk Name and path of a file with workpiece
correction data. After a complete (!)
download, this file is transferred to the
NCR for presetting.
wtk=default.wtk Name and path of a file with tool
correction data. After a complete (!)
download, this file is transferred to the
NCR for presetting.
magazinplaetze=9 Information on the released S coordinate
systems in the magazine management (a
maximum of 100 S systems are available
at the same time).
KSxx=a,c−e,g
KSyy=e Information on the relationship between
magazine position (a, c−e,..) and
corresponding S coordinate system (xx and
yy). The entry can be made in the form of
an enumeration (a, c, d, e..) or by specifying
a range (c−e).
[SPS−Tasten] In this section, freely configurable "PLC
key" commands can be entered. They can
then be called within the MMI software
from any softkey menu via a "hotkey",
which is also configurable.
The key information (max. 128) is reported
to the PLC via DB1 DW212−219.
KeyCode=Shift−F8 Determines the key combination for
showing and hiding the alternative softkey
menu with the PLC key functions defined
in the following. A valid entry consists of
the specification of a function key
(F1 .. F12) and optionally their linkage with
any combination of the control keys
"Shift", "Alt" and "Ctrl".