Lenze ETC Motion Control - Manual (Page 47)

Getting started
Creating a CNC sample program
Calling the text editor in the ETC−MMI
2
2.10
2.10.1
l
47 EDSTCXN EN 2.0
2.10 Creating a CNC sample program
2.10.1 Calling the text editor in the ETC−MMI
1. If required, start the ETC−MMI via W Programs W Lenze W ETC.
The ETC−MMI window opens.
ETCN011
2. In the ETC−MMI window, press (program).
The MMI window opens in the "Programming" operating mode. It shows
the text editor for entering the CNC program.
3. Press (Graphics) and afterwards (Graphics on/off).
The window is split. The text editor is displayed on the left, the display
field for the graph (graphic area) on the right. In the top left of the text
editor, the cursor flashes.
ETCN014