Etc−mmi – Lenze ETC Motion Control User Manual
Page 329
ETC−MMI
Appendix
Configuration file (DELPHMMI.INI)
7.8
7.8.3
l
329
EDSTCXN EN 2.0
Description
Term
Section
helpfile=c:\Programs\Lenze\ETC\m
mi\
ncform31.hlp
This term offers the possibility that the
MMI software shows online helps. If the
file name of a Windows help file is
specified, the online help is displayed in
Windows format.
If only a directory (e.g.
c:\Programs\Lenze\ETC\mmi\
help) is specified, the standard software
shows help texts in the form of ASCII files.
The ASCII files must be located in the
specified directory. In the MMI software,
the function−related help is opened by
simultaneously pressing the "Control" key
and a function key. The name convention
of the file that is displayed is
NewTast=0
To activate the key of the IPC with the
second function without keyboard driver,
NewTast must be set to 1. By default, the
keyboard driver is installed and NewTast =
0.
Scanzposfile= testaufz.txt
Default name of the ASCII file in which the
position values are saved in ASCII format.
Zposkorrfile= testaufz.kor
3D correction file is transferred to the
control system.
saveanddownload=0
If SaveAndDownload is set to 1, a program
is transferred immediately to the control
system when it is saved during
programming.
startcycle=12345
This term is used during programming of
cycles (see also "cycle programming").
[machineconstants]
mk=default.mk
This file contains machine constants that
are transferred to the NC computer. The
transfer only takes place if the HMI
software is started and no operating
system is running on the NC computer. If
required, the NC computer must be reset
to transfer the machine constants.
mkhlp=mk.hlp
This file contains help texts that are
displayed when machine constants are
changed by means of the MMI (Diagnostics
operating mode – Machine const. function)
−> edit MC).
[download]
entry1=ETCxC; .\cfg\ETCxC.rsc;
Operating system for the NC computer:
The operating system is only transferred
after a reset of the NC computer.
entry2=ncr; .\cfg\spsdummy.prg;
PLC program:
The PLC program is only transferred after a
reset of the NC computer.
Note: After each installation, a manual
entry is required here. You must specify
the PLC file that you use here.
[programs]
entry0=d:\demo\std\
cfg\9000.zyk
DIN program:
If you want to load multiple DIN programs,
multiple terms (entry1=..., entry2=... etc.)
must be specified. The program is only
transferred after a reset of the NC
computer.