Lenze ETC Motion Control - Manual (Page 333)

ETC−MMI
Appendix
Configuration file (DELPHMMI.INI)
7
7.8
7.8.3
l
333 EDSTCXN EN 2.0
Description Term Section
KEYxxx=yyyy
.
.
KEYmmm=nnnn,oooo Determination of the properties of the
"PLC key" to be activated:
l Behaviour as key or switch,
l the sequence of the execution of the
functions on the softkeys
l the labelling of the softkeys are
achieved by entries of the type KEYxxx=
yyyy or KEYmmm=nnnn,oooo.
The value "xxx" describes the index of a bit
within the "virtual keyboard" (DB1
DW212−DW219) of the PLC; the value
"yyyy", "nnnn" or "oooo" references the
entries in the language file for labelling the
corresponding softkeys. If 2
comma−separated language file references
are entered ("nnnn,oooo"), the softkey
behaves like a switch. Depending on the
switch state, the labelling is changed:
"nnnn" stands for the switch state "off",
"oooo" for "on".
The sequence of the entries corresponds to
the execution of the PLC key functions on
the horizontal softkey line. If more than 8
functions are defined (an entry of the type
KEYxxx=−1 defines an empty key), a
function for incrementing is offered on the
8th softkey,e.g.:
The Ini file contains:
Key0 =2800,2927
Key12 =2818,2911
Key13 =−1
Key3 =2812
Key19 =2814
Key29 =2809
Key123 =2801
Key14 =2817
Key22 =2803
Key23 =2805
The language file contains:
00002800,"
[0]@C12632256@FArial,8,1,0,3,6"
00002801,"
[1]@C12632256@FArial,8,1,0,3,6"
:
00002926,"[126]@C12632256@FArial,8,1,
0,3,6"
00002927,"[127]@C12632256@FArial,8,1,
0,3,6"
This results in 2 softkey lines with the
following structure:
[00] | [18] | | [12] | [14] | [09] | [01] |more..
[17] | [03] | [05] | | | | |more..
After "[00]" has been actuated, the
labelling for softkey 1 changes to [127]
[127] | [18] | | [12] | [14] | [09] | [01]
|more.
Please note that the relationship between
the softkey labelling, the set bit in the PLC
keyboard and the reaction of the machine
is only established by the programmed
procedures in the PLC.