Lenze ETC Motion Control - Manual (Page 313)

ETC−MMI
"Diagnostics" operating mode
7
7.7
l
313 EDSTCXN EN 2.0
Diagnostics data...
NC timing information Display different internal control−specific data. The
function is intended for internal use only or for trained
service personnel. The display can be cleared with the
key.
Trace Open dialogue for activating events that are to be
logged. From the list of available traces, individual
traces can be selected with a double−click and activated
with . You will then be prompted to enter a file
name (e.g. \log\ETC_MMI.trc). The events will be
written to this file. The activations will be reset when
the MMI is quit.
Axis information Show parameters of the configured axis.
Dump The file "IBprot.txt" is created in the "\log" directory
and displayed. It contains information on the system
(inter alia DelphMMI.ini, current machine constants,
current tool data, contents of the P fields). This way,
relevant data can be collected if problems occur.
DPR Display the structure of the complete DPRs with the
current values.
ETCN084
Version information Version information on the ETC−MMI, firmware etc.
ETCN085
back... Back to the previous level.