Etc−mmi – Lenze ETC Motion Control User Manual
Page 294
ETC−MMI
"Setup" operating mode
7.4
l
294
EDSTCXN EN 2.0
Target position
Target position for the selected axis. Select the desired
axis by means of the
entry must be completed with
the entry and restores the old positions. The function
key is only labelled and enabled if the
Handwheel
The handwheel keys are only displayed if a
handwheel is configured in the machine constants.
Traversing the axes via a handwheel. You can select the
axis which you want to traverse by means of the
handwheel via the
Handwheel factor
Selection of a factor which acts on the traversing speed.
5 handwheel factors are provided (1, 3, 10, 30, 100).
Every time the
following factor is selected. The function key is only
labelled and enabled if the
pressed.
back...
Back to the previous level.
Datum points...
Reset
The actual position of the selected axis is set to zero
(zero shift).
Import
The actual position of the selected axis is set to the
entered value.
Correct
The actual position of the selected axis is shifted by the
entered value.
S switchover
Enter the number of the workpiece coordinate system
(S), complete with
entered coordinate system is activated.
back...
Back to the previous level.
Tool management...
Management of tools and the corresponding change
positions.
Up to 99 tools can be entered and saved. Tool "0" serves
as reference tool and should not be used otherwise. The
tools can be assigned 99 tool magazine positions. Please
note that each magazine position reduces the number
of workpiece coordinate systems (max. 99).
The number of tools and magazine positions managed
in the MMI is determined in the "DelphMMI.ini"
(
^ 327). 30 parameters are available for each tool, six
of which have a fixed meaning:
l
Tool length
l
Tool radius
l
Tool life
l
Speed
l
Magazine position
l
Sister tools
The data is made available in the parts program in the P
field (P700 ... P729) when the tool is selected.