Getting started – Lenze ETC Motion Control User Manual

Page 26

Text mode
Original mode

Getting started

Establishing the communication between PC and ETCHx
Setting the operating mode of the ETCHx

2.4
2.4.3

EDSTCXN EN 2.0

For the "With MMI" operating mode, the firmware file must be replaced by
the file "NetBoot.rsc" (Loader) on the ETCHx.

1. To delete the firmware, enter the following in the HyperTerminal: del

sd: etc*.rsc. Afterwards, press the key.

2. To transfer the Loader to the ETC, activate the menu item Transfer

Send File in the HyperTerminal.

ETCM021

3. Specify the path to the file "NetBoot.rsc" and select the protocol

"Zmodem with Crach Recovery".

ETCM022

4. Click on Send.

While the file is being loaded into the control system, the following figure
is displayed. On the ETC front plate, the LEDs 1 ... 6 flash circulatingly.

ETCM023

Set the "With MMI" operating
mode