Lenze ETC Motion Control - Manual (Page 319)

ETC−MMI
"Diagnostics" operating mode
7
7.7
l
319 EDSTCXN EN 2.0
EDS Load description file of a manufacturer of a CAN
module. All defined code positions can be read out. The
code positions released for writing can be overwritten
with new values. For details, refer to the module
description of the manufacturer of the CAN modules.
If the softkey is pressed, a selection of the CAN bus
(1:I/O bus, 2:drive) is displayed first. Afterwards, the
node number of the desired module must be specified.
In the following dialogue, the description file (*.eds) of
the module type is selected. The selected module can
now be accessed.
ETCN094
back... Back to the previous level.
Edit password After the softkey has been pressed, a dialogue is
displayed. The password for changing passwords must
be entered here (
^ 292.) Afterwards, a selection list is
displayed where the password to be changed must be
selected. You will then be prompted twice to enter the
new password in order to avoid possible errors. New
passwords become active immediately after the change.
If you do not want a password for certain operating
modes, enter an empty string as active password.
MMI configuration Display and change configuration file "DelphMMI.ini"
(
^ 327). Every tab represents a section of the Ini file.
Use the button in the right bottom to add a new entry
below a section. It can, for example, be used to enter
cycles in the "programs" section. These cycles will be
loaded on startup.
ETCN095