Lenze ETC Motion Control - Manual (Page 325)

ETC−MMI
Appendix
Cycle programming
7
7.8
7.8.2
l
325 EDSTCXN EN 2.0
In the configuration file "delphmmi.ini", the following parameters can be set
in the "e/a anzeige" ("I/O display") section:
textbasisnr: Basic number where the I/O signal texts start.
separate_karten_texte: Can be used to determine whether separate texts
are to be entered for each I/O module.
1: Separate texts for each module
0: The texts of module 1 are used for all modules
[e/a anzeige]
textbasisnr=30000000
seperate_karten_texte=1
7.8.2 Cycle programming
For each cycle, an entry with the specification of the cycle number in the form
of a section name (Lxxxx, where 8000
≥
xxxx
≥
9999) and a clear text name
must be created. This name is displayed in the "Programming" operating
mode when the cycle is selected.
In the Lxxxx sections, the input parameters to be offered are determined. In
addition, a bmp file can be specified. It will be displayed when the cycle is
selected.
An input parameter is defined by a P field number, in which the input value
is transferred to the cycle.
ƒ Default value
ƒ Minimum value (optional)
ƒ Maximum value (optional)
ƒ Identification for mandatory input (optional)
ƒ Display text
enty(n) = [pfeldnr.] = x.xx; [Min]; [Max]; [Flag]; [Text]
In the following, some examples of cycles and their parameters are shown:
Section Term Description
[Zyklen]
entry1 = L8000; grinding entry1: is required for identification.
L8000: section name under which the
cycle and the cycle number are
described.
grinding: text for display and selection
entry2 = L8001; sawing
entry3 = L8002; sewing
entry4 = L8003; free
entry5 = L8004; free
Settings in the configuration
file "delphmmi.ini"
Example