ETC Unison Mosaic Designer v1.11.0 - Manual (Page 203)

AVC Recovery Tool
How to use it
Connect the AVC via USB
Use a DC supply to power the AVC and then connect to a PC with a standard USB cable. If prompted to install
the USB driver, follow the steps in the Found New Hardware wizard, selecting to install the driver automatically.
Run the tool
On Windows this tool can be launched from the Start menu under Programs > Mosaic > Designer. Unison Mosaic
Designer must be closed before launching this tool.
To update the firmware to the latest version (v1.11) press "Update Firmware" and the process will begin, taking a
few seconds to complete during which time you must not disturb the USB connection, the PC nor the AVC in any
way. Should this process be interrupted or fail for some reason then try again. Press Exit to finish.
- 203 -