ETC Unison Mosaic Designer v1.11.0 - Manual (Page 179)

Issues
DALI programming has changed on Interface '?' since the
ballast configuration was last uploaded
Update the DALI ballasts, see DALI
Timeline '?' uses Timecode Bus '?' but no input is con-
nected to that source
Ensure that the timecode source routed to that bus
Timeline '?' uses Audio Bus '?' but no input is connected to
that source
Ensure that the audio source routed to that bus
Timeline '?' uses band '?' on Audio Bus '?' which is not
provided by the assigned input Select a band that is available for that bus, or
change the source for the bus
Trigger '?' will not be matched because controller '?' is not
a TPC Reconfigure the trigger with the correct Controller
number
Trigger '?' is set to match on controller '?', but no controller
has that number Reconfigure the trigger with the correct Controller
number
'?' is set to match with '?' module number '?' on any con-
troller, but no such module is configured
Add and configure the Expansion Module
'?' is set to match with '?' module number '?' on controller
'?', but no such module is configured
Add and configure the Expansion Module
'?' is set to match with '?', but no such device is configured Add and configure the Remote Device
'?' has an incomplete remote device identifier
Reconfigure the trigger or action with the correct
Remote Device identifier
There are Astronomical triggers in the project, but the pro-
ject location appears to have not been set
Set a location for the project, see Location
Trigger '?' requires input '?' on controller '?' to be con-
figured as a digital input or contact closure The Controller's input has been configured incor-
rectly, see
Controller Interfaces
Trigger '?' requires input '?' on controller '?' to be con-
figured as an analog input The Controller's input has been configured incor-
rectly, see
Controller Interfaces
Trigger '?' is set to match with controller '?', which doesn't
have digital inputs
Choose a Controller that does have digital inputs
Trigger '?' is set to match with controller '?', which doesn't
have analog inputs
Choose a Controller that does have analog inputs
Trigger '?' requires a serial port, but controller '?' doesn't
have a serial port
Choose a Controller that does have a serial port
Trigger '?' is set to match with controller '?', which requires
the serial port to be set to 1 Controller only supports one serial port, so set the
trigger serial port to 1
Trigger '?' requires the serial port on controller '?' to be set
to RS232 Reconfigure the serial port of the Controller to use
the correct mode, see
Controller Interfaces
Trigger '?' uses the RS485 serial port, but controller '?'
doesn't have an RS485 serial port Reconfigure the trigger to use a Controller that does
have an RS285 serial port
- 179 -