ETC Unison Mosaic Designer v1.11.0 - Manual (Page 193)

Output viewer
Output viewer
Select View > Output viewer on the main toolbar to open this window:
Use the Controller, Protocol and Universe pull-downs to select the Controller and DMX universe that you wish to
view. What you will see depends on the status of your
patch and the simulator :
Unpatched universe
If the universe is not patched then all values will be zero (0) regardless of the simulator's status.
Patched, simulator not running (reset)
If the universe is patched and the simulator is not running then you will see the default values for the fixtures.
These are the values that the Controller will output after a reset or power cycle and prior to a timeline running, see
Precedent .
Patched, simulator running (playing or paused)
If the universe is patched and the simulator is running then you will see the values that the Controller will generate
when it runs this timeline. Designer uses exactly the same playback algorithms as the Controller so what you see
with the DMX viewer is what you'll get with the Controller.
- 193 -