Controller firmware, To update a controller's firmware – ETC Unison Mosaic Designer v1.11.0 User Manual
Page 139
Network - Controller connection
If a controller is on a different network, and is not discovered on USB, it will appear as grey in the network spread-
sheet. If a controller is on a different network (regardless of discovery on USB), a warning message is shown in
the Controller Config tab.
Controller firmware
IMPORTANT: Controllers must be running the same version of firmware as the Designer software. Controllers
with incompatible firmware will be highlighted in red.
To update a Controller's firmware:
1. Select the incompatible Controller by pressing the left hand button, the row will be highlighted
2. Press Reload Firmware on the network toolbar
3. The firmware update will proceed - you must not disturb this process
Alternatively a utility application is provided that also allows you to update the MSC X's bootloader and firmware,
see
. There is a
for the TPC and MSC 1/2/4.
The TPC-RIO's firmware is updated directly from the TPC. If the TPC detects that a connected TPC-RIO has the
wrong firmware version then it will automatically update it - you must not disturb this process. The TPC-RIO's
'TPC Active' LED will illuminate continuously when this process has completed successfully.
- 139 -