ETC Unison Mosaic Designer v1.11.0 - Manual (Page 159)

Network - Remote Devices
Network - Remote Devices
Please refer to the documentation supplied with the units for hardware details and installation instructions.
Connection
Remote Devices can only be connected using a Power over Ethernet (PoE) connection so a suitable PoE
repeater or switch must be provided.
TCP/IP
Since the Remote Devices do not use TCP/IP, connection is more straightforward than with the Controllers,
simply connect them to the network and use the thumb wheel on the device to set an Address, see Associating
Remote Devices below.
Multicast
Remote Devices do however use a block of Multicast addresses for communication so these addresses must be
available: 230.0.0.0, 230.0.3.1, 230.0.3.2 & 230.0.3.3. Please be aware that managed Ethernet switches which
may block these addresses by default.
The bottom half of the Network window allows you to manage and configure any Remote Devices in the project
and found on the network:
- 159 -