ETC Unison Mosaic Designer v1.11.0 - Manual (Page 161)

Network - Remote Devices
To delete a project Remote Device:
1. Select the project Remote Device by clicking the left hand button, the row will highlight
2. Press Delete Device on the Remote Device toolbar
3. The Remote Device will be removed from the project and, if no longer associated at all,the real device will
move to the Unused list
Remote Device firmware
IMPORTANT: Remote Device firmware may need to be updated if a new version of Designer software has been
installed. Devices with incompatible firmware will be highlighted in red.
To update a Remote Device's firmware:
1. Select the incompatible device by pressing the left hand button, the row will be highlighted
2. Press Reload Firmware on the Remote Device toolbar
3. The firmware update will proceed - you must not disturb this process
Associating Remote Devices
Unlike Controllers, which are uniquely associated with a project via their serial number, Remote Devices are
associated by their address as selected on the unit itself. Fifteen automatic addresses (1>15) are provided with a
manual option (M) for selecting more (16>100). Remote devices may share the same address and thus identity,
useful for repeating a user interface at both ends of a corridor for example.
To associate a project Remote Device with a real device (automatic addresses 1>15):
1. Select the project Remote Device by clicking the left hand button, the row will highlight
2. Ensure that the device type and address matches a suitable unit, addressed at this number, found on the
network
3. The real device will move from the Unused list and fuse with the project device so completing the row
details
To associate a project Remote Device with a real device (manual addresses 16>100):
1. Ensure that the Remote Device is addressed to the "M" setting, you will need to note it's serial number
(label on back)
2. Select the project Remote Device by clicking the left hand button, the row will highlight
3. Select the correct device type and the desired address in the range 16>100
4. Select the Remote Device's serial number from the pull-down menu of devices found on the network
5. The real device will move from the Unused list and fuse with the project device so completing the row
details
Once all your project Remote Devices have been associated with real devices you can configure them, test your
programming on the installation itself and finally upload to the Controllers for stand-alone operation.
- 161 -