Apple Logic Pro 9 - Manual (Page 110)

To hide or show the Inspector in the Arrange window
Do one of the following:
µ
Choose View > Inspector (or use the Hide/Show Inspector key command, default
assignment: I).
µ
Click the Inspector button in the Arrange toolbar.
To hide or show the Inspector in the editing windows
µ
Choose View > Inspector (or use the Hide/Show Inspector key command, default
assignment: I).
If there is not enough vertical room to display all areas of the Inspector, you can click the
disclosure triangles to hide the individual boxes.
Adjusting the Bar Ruler Display
You can switch the Bar ruler between four display modes:
• Time: Displays a SMPTE time ruler, divided into hours, minutes, seconds, and frames.
• Bar: Displays a Bar ruler, divided into bars, beats, divisions, and ticks. Depending on
the zoom settings (see Zooming the Working Area ), the bars are shown at the top edge
in units of 1, 4, 8, or 16. Changes in time signature are also shown here. In the bottom
third, there is a vertical line for each bar. The shorter lines represent one beat, but are
not always visible (depending on the zoom setting).
• Bar and Time: Displays the SMPTE ruler above the Bar ruler.
110 Chapter 4 Customizing Your Window Setup