Spectra Precision ProFlex 800 Reference Manual - Manual (Page 90)

76
Using the Web Server
• Click on the Configure button to let the Web Server load all
your new parameters to the receiver and the radio. You
have now reached the end of the configuration phase.
Direct IP Via
Modem
The internal modem should be configured first:
• Click on the Connections menu and then on the Bluetooth/
Modem sub-menu.
• Set the following parameters in the Internal Modem/Device
Settings pane:
–
Power: Select “On”. Then choose whether the modem
should be turned on automatically or manually:
Automatic: The modem will be switched on or off
automatically when the base is respectively turned on
or off.
Manual: The modem will be powered up only by going
through the
Connections > Bluetooth/Modem page and
setting the modem to “Power On” (or using the
$PASHS,MDM,ON command).
– Automatic Connection: Check this option.
– 2G Only: Enabling this check box will limit the use of
the modem only if a 2G mobile communication
network is available in the working area. When it is
cleared, the modem will be allowed to operate either in
a 2G or 3G network, whichever is available.
– Pin: 4- to 8-character pin code of the SIM card used in
the modem for GPRS operation.
• Set the following parameters in the Internal Modem/GPRS
Mode Settings pane (the mobile communication provider
you are using should be able to give you all this
information):
– Internet Protocol: Choose the Internet protocol (TCP or
UDP) allowing the modem to perform an Internet
connection.
Modem
(Client)
ProFlex 800
(Mobile Wireless
Communication)
Internet
Users