Spectra Precision ProFlex 800 Reference Manual - Manual (Page 422)

408
Set Command Library
See also $PASHS,NME,PER
NME,ALL: Disabling All NMEA and NMEA-Like Messages
Function This command is used to disable all NMEA messages and
NMEA-like messages currently enabled on the specified port.
Command Format Syntax
$PASHS,NME,ALL,c1,OFF[*cc]
Parameters
Example
Disabling all NMEA and NMEA-like messages on port A:
$PASHS,NME,ALL,A,OFF*50
NME,PER: Setting Unique Output Rate for all NMEA Messages
Function This command is used to set the same output rate for all
NMEA and NMEA-like messages. This command will
overwrite all the output rates set individually for each
message type using $PASHS,NME,xxx.
Command Format Syntax
$PASHS,NME,PER,f[*cc]
Parameter Description Range
c1
Port ID
A, B, F: Serial portC: Bluetooth port
I, P, Q, I1-I9: Ethernet port
E: Modem
M, U: Memory
R: Data recording through session
A, B, C, E, F, I, M, P, Q,
R, U, I1-I9
*cc Optional checksum *00-*FF