Spectra Precision ProFlex 800 Reference Manual User Manual

Page 72

Using the Web Server

–

Pin: 4- to 8-character pin code of the SIM card used in
the modem for GPRS operation.

–

2G Only: Recommended to save power.

• Set the following parameters in the

Internal Modem/GPRS

Mode Settings pane (the mobile communication provider
you are using should be able to give you all this
information):

–

Internet Protocol: Choose the Internet protocol (TCP or
UDP) allowing the modem to perform an Internet
connection.

–

Access Point: Enter the URL of the mobile
communication provider.

–

Access Point Login: Enter the login of the mobile
communication provider.

–

Password: Enter the password of the mobile
communication provider.

• Click on the

Configure button.

• Now please follow all the steps described in section

General Parameters on page 49 and then proceed with the
steps below.

• Still on the

Rover Setup page, in the Network pane, set the

following parameters:

–

Connection: Choose “Modem Ntrip Client - Port E”. As
a result, new fields appear in this pane that you should
set as instructed below:

–

Connect Now: Enable this option to allow the receiver to
establish the connection right after you have clicked
on

Configure.

–

Address, Port, Login, Password: Enter the information
allowing the receiver to connect to the NTRIP caster.
This information should have been passed on to you
earlier by the administrator of this service.

–

Load Source Table button: Click on this button after you
have entered the information about the NTRIP caster.
As a result, the list of available sources from this caster
appears just underneath. (See example below.)