Spectra Precision ProFlex 800 Reference Manual - Manual (Page 6)

ii
Rover Using Internal Radio .....................................................267
Rover Using Port A as Corrections Input ..................................268
Rover Using Port B or F as Corrections Input ............................268
NTRIP Rover (Via Modem).......................................................269
Direct-IP Rover (Via Modem) ...................................................270
Rover Operating in Long-Range Flying RTK Mode .....................272
Base With External Pacific Crest Radio Transmitter ..................272
Base With Internal Radio Transmitter ......................................273
Base With Ashtech Radio Transmitter ......................................274
Base Using Port A as Corrections Output .................................276
Base Using Port B or F as Corrections Output ...........................276
Base Using the Ethernet Port as the Corrections Output ............277
Direct-IP Base (Via Modem) ....................................................278
NTRIP Station........................................................................280
Chapter 7. Ethernet Connection ..................................................... 283
Setting Up the Ethernet Connection .........................................283
Using the Ethernet Port ..........................................................285
Chapter 8. Using Serial Commands ................................................ 291
Introduction to Serial Commands .............................................291
Applying Commands Through Bluetooth or a Serial Port .............292
Applying Commands Through TCP/IP........................................294
Running Serial Commands from a USB Key ..............................298
List of Commands ..................................................................299
Chapter 9. Set Command Library.................................................... 309
AGB: Enabling/Disabling GLONASS Bias Adjustments ...............309
ANH: Antenna Height .............................................................310
ANP,DEL: Delete User-Defined Antenna ...................................310
ANP,OUT: Defining a Virtual Antenna.......................................312
ANP,OWN: Naming the Local Antenna .....................................313
ANP,PCO & ANP,EDx: Creating/Editing Antenna Definitions .......315
ANP,REF: Naming the Antenna Used at the Base ......................316
ANR: Antenna Reduction Mode ...............................................317
ANT: Antenna Height..............................................................318
ATL: Debug Data Recording.....................................................320
ATM: Enabling/Disabling ATOM Messages ................................321
ATM,ALL: Disabling All ATOM Messages...................................323
ATM,PER: Setting Unique Output Rate for all ATOM Messages ...324
ATM,VER: Setting the Version of ATOM Messages .....................324
BAS: Differential Data Type.....................................................325
BDS: Setting Differential Data Streams on Ports Ix ....................327
BEEP: Beeper Setup...............................................................328
BRD: Enabling/Disabling the RTC Bridge Function ....................328
BTH,NAME: Bluetooth Device Name ........................................332
BTH,OFF: Disabling Bluetooth .................................................333
BTH,ON: Enabling Bluetooth ...................................................333
BTH,PIN: Bluetooth Device Pin Code .......................................334