Spectra Precision ProFlex 800 Reference Manual - Manual (Page 212)

198
Web Server Help Files Collection
Advanced Setup (Configuration Tab)
Terminal Window This section is used to communicate with the receiver
through $PASH commands. The purpose and syntax of each
available $PASH command is described in detail elsewhere
in this manual.
To send a command to the receiver, type your command in the
Command field and then click on the Send button. In the pane
underneath the
Command field, you will see your command
duplicated in blue characters followed by the response line,
in orange characters, returned after a while by the receiver.
The commands you type and send are all stacked up into the
Command field so it is easy for you to re-select and re-send
one of those when needed.
Use the Clear View button to clear out the page.
If alarms have been set in the receiver, you may click on the
Acknowledge Alarms button to acknowledge all these alarms.
As a result, the $PASHS,WAK command is issued to perform
this operation in the receiver.
Software Update This page allows you to upgrade the firmware of the receiver
if a new version is available from the specified FTP server.