Spectra Precision ProFlex 800 Reference Manual - Manual (Page 349)

335
Set Command Library
Parameters
The possible GNSS tracking configurations are detailed in the
table below.
Default Settings
They depend on the presence or not of firmware options ([P]
option for L2, [Q] option for L5). See tables below (the
$PASHS commands detailed in some of the cells below
describe the resulting default settings, as if you had run these
commands at start-up).
Parameter Description Range
s1
GNSS tracking configuration:
• SSL: Single-signal tracking
• DSL: Dual-signal tracking
• TSL: Triple-signal tracking
SSL, DSL, TSL
*cc Optional checksum *00-*FF
Single Signal Dual Signal Triple Signal
GPS Tracking
14 GPS
(similar to
$PASHS,GNS,CFG,
0 or 1)
See $PASHS,GPS
command See $PASHS,GPS
command
GLONASS
Tracking
14 GLO (L1 only) 14 GLO (L1+L2) 10 GLO (L1+L2)
GALILEO
Tracking
8 GAL E1 only 8 GAL (E1+E5a) 8 GAL (E1+E5a)
SBAS Track-
ing
2 + SBAS 2 SBAS 2 SBAS
Common
Defaults
[Q] Option Enabled No [Q] Option
[P] Option
Enabled Default is DSL;
GPS,ON,1C,2LW
No [P] Option
Default is DSL;
$PASHS,GPS,ON,1C,5Q Default is SSL;
$PASHS,CFG,DSL is NAKed
TSL Defaults [Q] Option Enabled No [Q] Option
[P] Option
Enabled
$PASHS,GPS,ON,1C,2LW,L5 $PASHS,GPS,ON,1C,2W,2L
No [P] Option $PASHS,CFG,TSL is NAKed $PASHS,CFG,TSL is NAKed