Spectra Precision ProFlex 800 Reference Manual - Manual (Page 189)

175
Web Server Help Files Collection
Before you select a message type from the drop-down list, you
can hold the mouse cursor over this message name in the
drop-down list. After about one second, a tip box will appear
providing the full definition of this message.
Note that for messages PTT, TTT and XDR, you don’t have to
define an output rate, due to the very nature of these
messages.
To change the settings of an existing message (port, rate),
select the corresponding row in the table. This populates the
three fields on the left with the settings of that message. Edit
the port and/or rate and then click on the
Modify button. The
table row is updated accordingly. Remember you must always
click on the
Configure button to save the changes in the
receiver.
Note that depending on the current selection on this page,
the button located underneath the three fields on the left may
be either grayed or with a different label (
Add or Modify).
Deleting a message definition can be done by simply clicking
on the corresponding “trash” sign in the
Clear column on the
far right. This deletes the table row.
There is also a Clear All button underneath the table that
allows you to delete all the message definitions from the table
in one click.
Raw Data
Two data formats are possible:
• ATOM (navigation data and other data)
• Ashtech Legacy (navigation data and other data)